Ultra-strong and super-fast, programmable digital micro servo with metal gears and double ball-bearing output shaft. The servo was specially designed for 1:12 scale road racing cars and developed in collaboration with European champion Max Mächler. For easy installation in various types of chassis, the servo is housed in a plastic casing which is equipped with both normal feet and feet for flat mounting. Increased supply voltage 3.7-7.4 V (nominal voltage), operating voltage 3.5-8.4 V. With the USB programmer/interface for DSP-1 servos and the PC operating program, you can program a wide range of servo parameters:   STANDARD FUNCTIONS

• Dead band: The signal value can change under certain circumstances without affecting the position of the output shaft/servo lever. MKS default value = 1μs or 1.2μs

• Lock (Close): Setting the servo behavior when it does not receive a control signal - Holds the position corresponding to the last signal received / The motor is free, the servo does not hold a position.

• Max. Duty: The motor power is limited by this value - it limits the maximum power of the servo motor.

• Pulse Lower: The lower limit of the control pulse width and the corresponding size of the servo deflection are limited by this value.

• Neutral (neutral position): Sets the width of the control pulses in the neutral position/center position of the servo.

• Pulse Upper (max. pulse width): The upper limit of the control pulse width and the corresponding size of the servo deflection are limited by this value.

• Boost: Motor power when starting from a standstill. The higher the value, the stronger the motor starts.

ADVANCED FUNCTIONS

• Left Angle: Max. Left servo deflection size.

• Right Angle: Max. servo deflection on the right. Servo deflection size right.

• Reversion: Reverses the direction of the servo deflection.

• Allow Uncont (switch on fail-safe): If the control signal fails, the servo activates the preset emergency position, which corresponds to the value "Uncontrolled Position".

• Uncontrolled Pos: If the " Allow Uncont" option (activate fail-safe) is switched on, the servo's fail-safe is set in the event of a signal loss.

• Uncontrolled Time: In the event of signal loss, the servo moves to the emergency position "Uncontrolled Position" after the "Uncontrolled Time" waiting time.

FEATURES Servo size: Micro Servo type: Digital Programmable: Yes Actuating force with 3.7 V [kg∙cm]: 3.75 Actuating force with 6.0V [kg∙cm]: 6.1 Actuating force with 7.4V [kg∙cm]: 7.5 Actuating force with 8.2 V [kg∙cm]: 8.3 Speed at 3.7 V [s/60st.]: 0.157 Speed at 6.0V [s/60st.]: 0.097 Speed at 7.4V [s/60st.]: 0.079 Speed at 8.2 V [s/60st.]: 0.071 Control pulse width in the neutral position [µs]: 1520 Frame frequency [Hz]: 333 Dead zone [ms]: 0.001 Servo gear: Metal Ball bearing: 2× High voltage: Yes Power supply [V]: 3.7 - 8.4 Length [mm]: 27 Width [mm]: 12.1 Height [mm]: 27.7 Weight [g]: 18.1 Intended for: 1:12 Pan Car Road cars